AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 223
ADD SWITCH TRUNK
Syntax
add switch trunk=
trunk_name
port=
port_list
Parameters
trunk_name
Specifies the name of a trunk group.
port_list
Specifies a list of ports to add to the trunk group. One trunk can
have up to 8 ports. To specify multiple ports, use a comma (,) to
separate them. To specify a range of ports, use a hyphen (-).
Description
Use this command to add a list of ports to a trunk group. For the guidelines
for trunk groups, see page 224.
Confirmation Command
“SHOW SWITCH TRUNK” on page 278
Example
The following command adds port 1 to the trunk uplink:
Manager > add switch trunk=uplink port=1