Allied Telesis AT-GS900M Series User Manual

Chapter 7: SNMP Commands
142 Section II: Switch Management
SHOW SNMP TRAP
Syntax
show snmp trap[= trap | all]
Parameters
trap
Specifies a trap type. For a list of trap types, see “CREATE SNMP
COMMUNITY” on page 115.
all
Specifies all trap types.
Description
Use this command to display a list of trap statuses or the information
about the specified trap. An example of the command output is shown in
Figure 22.
Figure 22. SHOW SNMP TRAP Command
Manager > show snmp trap
SNMP Trap Information:
-------------------------------------------------
Cold Start ................... Enabled
Warm Start ................... Enabled
Authentication ............... Enabled
Fan .......................... Enabled
Link ......................... Enabled
Temperature .................. Enabled
Voltage ...................... Enabled
Newroot ...................... Enabled
TopologyChange................ Enabled
PoE........................... Enabled
Login ........................ Enabled
LoopDetection................. Enabled
StormDetection................ Enabled
Epsr.......................... Enabled
Mstp.......................... Enabled
Trigger....................... Enabled
Intrusion..................... Enabled
Sfp .......................... Enabled
Newaddress ................... Enabled
-------------------------------------------------

Allied Telesis AT-GS900M Series Specifications

General

Brand	Allied Telesis
Model	AT-GS900M Series
Category	Switch
Language	English