Allied Telesis AT-GS900M Series User Manual

AT-GS900M Series Command Reference
Section III: Layer 2 Switching 351
ENABLE TRIGGER
Syntax
enable trigger= trigger_id
Parameters
trigger_id
Specifies a power saving trigger ID.
Description
Use this command to enable a power saving trigger. Right after the trigger
is created, the trigger is enabled except the state parameter is set to
disabled.
Confirmation Command
“SHOW TRIGGER” on page 360
Example
The following command enables trigger 10:
Manager > enable trigger=10

Allied Telesis AT-GS900M Series Specifications

General

Brand	Allied Telesis
Model	AT-GS900M Series
Category	Switch
Language	English