Chapter 13: VLAN Commands
216 Section III: Layer 2 Switching
SHOW VLAN
Syntax
show vlan[=
vlan_name
|
vlan_id
|all]
Parameters
vlan
Specifies a VLAN with either the VLAN name or VLAN ID.
vlan_name
Specifies a VLAN name.
vlan_id
Specifies a VLAN ID.
all
Specifies all VLANs. This is the default setting.
Description
Use this command to display information about the specified VLANs. An
example of the command output is shown in Figure 34.
Figure 34. SHOW VLAN Command
The fields are described in Table 30.
Table 30. SHOW VLAN Command
Field Description
Name Displays the name of a VLAN.
Identifier Displays the VLAN ID.
Status Displays the status. It is always Static.
VLAN Information
--------------------------------------------------
Name ................ default
Identifier .......... 1
Status .............. Static
Protected Ports ..... None
Untagged Ports ...... All
Tagged Ports ........ None
Spanning Tree ....... default
Trunk Ports ......... None
Mirror Port ......... None
IP Interface ........ Yes
--------------------------------------------------
To Next Page
Loading...
