AT-GS900M Series Command Reference
Section III: Layer 2 Switching 353
SET LED MODE
Syntax
set led mode=speed|duplex|off
Parameters
speed
Sets the LED mode to speed. The LINK/ACT LED’s are on and the
SPD/DPX LED’s indicate the speed.
duplex
Sets the LED mode to duplex. The LINK/ACT LED’s are on and the
SPD/DPX LED’s indicate the duplex mode.
duplex
Turns off the port LED’s.
Description
Use this command to set the global port LED mode. When the port LED
mode is speed or duplex, the port LED’s are on.
Here are guidelines for the global port LED mode:
When the global port LED mode is off, the port LED settings on
ports specified by the SET LED PORT command have priority over
the global port LED mode.
The operations of the MODE button on the switch panel have
priority over the global port LED mode.
Confirmation Command
“SHOW LED” on page 359
Example
The following command sets the LED mode to off:
Manager > set led mode=off
To Next Page
Loading...
Need help?
General
