Allied Telesis AT-GS900M Series - Set Poe Threshold

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 341
SET POE THRESHOLD
Syntax
set poe threshold= threshold
Parameters
threshold
Specifies the percentage of the maximum power that the switch
supplies to the PDs.
Description
Use this command to specify the threshold that the switch supplies to the
connected PDs. The switch sends SNMP traps when the power supply to
the PDs exceeds or falls below the threshold. For example, when the
threshold is set to 80%, the switch sends SNMP traps when the power
supply to the PDs exceeds 80% of the maximum power or falls below 80%
of the maximum power.
Note
The PoE commands are available only for the GS908M V2-4PS
switch.
Confirmation Command
“SHOW POE” on page 342
Example
The following command specifies the threshold 80% of the maximum
power supply :
Manager > set poe threshold=80