AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 427
SHOW IGMPSNOOPING
Syntax
show igmpsnooping
Parameters
None
Description
Use this command to display the settings and status of IGMP Snooping.
An example of the command output is shown in Figure 64.
Figure 64. SHOW IGMPSNOOPING Command
Example
The following example displays the settings and status of IGMP Snooping:
Manager > show igmpsnooping
IGMP Snooping Configuration:
IGMP Snooping Status ............... Enabled
Host/Router Timeout Interval ....... 260 seconds
Maximum IGMP Multicast Groups ...... 64 (2)
Router Port(s) ..................... 1-3
IP Multicast Group Address ......... 224.1.1.1
Multicast MAC Address ............ 01-00-5e-01-01-01
Router Port(s) .................... 3
Host List:
Number of IGMP Multicast Groups: 2
VLAN Port/ IGMP Exp.
MulticastGroup ID TrunkID HostIP Ver Time
-----------------------------------------------------------------------
01:00:5e:7f:ff:fa 1 Port 13 192.168.1.101 v2 187
Router List:
VLAN ID Port/TrunkID RouterIP
---------------------------------------------------------
1 Port 1 192.168.1.254
1 Port 3 192.168.2.200
To Next Page
Loading...
Need help?
General
