Allied Telesis AT-GS900M Series User Manual

AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 513
SET PORTAUTH DHCPSERVER
Syntax
set portauth dhcpserver[=enabled|disabled]
[leasetime =
lease_time ]
Parameters
dhcpserver
Enables or disables the DHCP server for Authentication. By
default, the DCHP server function for Authentication is disabled.
leasetime
Specifies the lease time of an IP address. The default value is 20
seconds. The range is 10 to 86400 seconds.
Description
Use this command to enable or disable the DHCP server function for
Authentication and specify the lease time of an IP address.
When the DCHP server for Authentication is enabled, only the ports that
Web-Based Authentication is enabled on receive DHCP packets.
Confirmation Command
“SHOW PORTAUTH” on page 532
Example
The following command enables the DHCP server for Authentication:
Manager > set portauth dhcpserver=enabled

Allied Telesis AT-GS900M Series Specifications

General

Brand	Allied Telesis
Model	AT-GS900M Series
Category	Switch
Language	English