Allied Telesis AT-GS900M Series User Manual

Chapter 7: SNMP Commands
134 Section II: Switch Management
SHOW INTERFACE
Syntax
show interface= if_index | interface |all [counter]
Parameters
if_index
Specifies a port number.
ifterface
Specifies a port interface name. The port interface name is the
prefix port followed by a port number, such as port1, port2 and
port16.
all
Specifies all port interfaces.
counter
Specifies to display the counter information.
Description
Use this command to display the MIB information about the specified port
interface. An example of the command output is shown in Figure 17.
Figure 17. SHOW INTERFACE Command
Manager > show interface
Interfaces Information sysUpTime: 03:56:16
ifIndex Interface ifAdminStatus ifOperStatus ifLinkUpDownTrap ifLastChange
-------------------------------------------------------------------------------
1 port1 Up Down Enabled 00:00:00
2 port2 Up Down Disabled 00:00:00
3 port3 Up Down Disabled 00:00:00
4 port4 Up Down Disabled 00:00:00
5 port5 Up Down Disabled 00:00:00
6 port6 Up Down Disabled 00:00:00
7 port7 Up Down Disabled 00:00:00
8 port8 Up Down Disabled 00:00:00
9 port9 Up Down Disabled 00:00:00
10 port10 Up Down Disabled 00:00:00
11 port11 Up Down Disabled 00:00:00
12 port12 Up Down Disabled 00:00:00
13 port13 Up Down Disabled 00:00:00
14 port14 Up Down Disabled 00:00:00
15 port15 Up Down Disabled 00:00:00
16 port16 Up Down Disabled 00:00:00
-------------------------------------------------------------------------------

Allied Telesis AT-GS900M Series Specifications

General

Brand	Allied Telesis
Model	AT-GS900M Series
Category	Switch
Language	English