Allied Telesis AT-GS900M Series - Show Qos Dscp

AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 451
SHOW QOS DSCP
Syntax
show qos dscp
Parameters
None
Description
Use this command to display the DiffServ Code Point (DSCP) table on the
switch. An example of the command output is shown in Figure 67.
Figure 67. SHOW QOS DSCP Command
Example
The following example displays the DSCP table:
Manager > show qos dscp
QoS DSCP Table
DSCP Priority DSCP Priority DSCP Priority DSCP Priority
---------------- ---------------- ---------------- ---------------
0 0 16 0 32 0 48 0
1 0 17 0 33 0 49 0
2 0 18 0 34 0 50 0
3 0 19 0 35 0 51 0
4 0 20 0 36 0 52 0
5 0 21 0 37 0 53 0
6 0 22 0 38 0 54 0
7 0 23 0 39 0 55 0
8 0 24 0 40 0 56 0
9 0 25 0 41 0 57 0
10 0 26 0 42 0 58 0
11 0 27 0 43 0 59 0
12 0 28 0 44 0 60 0
13 0 29 0 45 0 61 0
14 0 30 0 46 0 62 0
15 0 31 0 47 0 63 0
---------------- ---------------- ---------------- ---------------