Allied Telesis AT-GS900M Series - Enable Portauth Port Logtype

AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 507
ENABLE PORTAUTH PORT LOGTYPE
Syntax
enable portauth[=all|8021x|macbased|webbased]
port=
port_list |all logtype=success|failure|logoff|all
Parameters
portauth
Specifies an authentication option.
all
Specifies all the authentication options.
8021x
Specifies 802.1x Port-Based Authentication using EAP.
macbased
Specifies MAC-Based Authentication.
webbased
Specifies Web-based Authentication.
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
logtype
Specifies a log type.
success
Specifies the log type of authentication success.
failure
Specifies the log type of authentication failure.
logoff
Specifies the log type of logoff.
all
Specifies all log types.
Description
Use this command to enable logging on the specified authentication option
and port By default, all log types are enabled.