Chapter 8: Simple Network Time Control (SNTP) Commands
160 Section II: Switch Management
SHOW SUMMER-TIME
Syntax
show summer-time
Parameters
None
Description
Use this command to display the Daylight Saving Time settings on the
switch. An example of the command output is shown in Figure 25.
Figure 25. SHOW SUMMER-TIME Command
Example
The following example displays the Daylight Saving Time settings on the
switch:
Manager > show summer-time
Local Time: Mon, 6 Aug 2014 13:56:06 +1200
UTC Time: Mon, 6 Aug 2014 01:56:06 +0000
Timezone: NZST
Timezone Offset: +12:00
Summer time zone: NZDT
Summer time starts: Last Sunday in September at 02:00:00
Summer time ends: First Sunday in April at 02:00:00
Summer time offset: 60 mins
Summer time recurring: Yes