Chapter 8: Simple Network Time Control (SNTP) Commands
158 Section II: Switch Management
SHOW NTP
Syntax
show ntp
Parameters
None
Description
Use this command to display the SNTP settings and SNTP counters. An
example of the command output is shown in Figure 24.
Figure 24. SHOW NTP Command
The fields are described in Table 19.
Manager > show ntp
---------------------------------------------------------
NTP Module Configuration
---------------------------------------------------------
Status : Enabled
Host Address : 192.168.1.5
UTC Offset : +09:00:00(JST)
Last Updated : 2011-04-12 at 11:23:16
Last Delta : 0
Configured Peer : 192.168.1.1
NTP Server Listen Port : 123
Counters
---------------------------------------------------------
Packets Sent : 0000000001
Packets Received : 0000000001
Packets w/head error : 0000000000
Packets w/data error : 0000000000
Table 19. SHOW NTP Command
Field Description
Status Displays SNTP is Enabled or Disabled.
Host Address Displays the IP address of the SNTP server.
UTC Offset Displays the offset from UTC.
Last Updated Displays the last time when the system time was
updated by the SNTP server.
To Next Page
Loading...
Need help?
General
