Chapter 17: DHCP Snooping Commands
322 Section III: Layer 2 Switching
SET DHCPSNOOPING CHECKINTERVAL
Syntax
set dhcpsnooping checkinterval=
time
Parameters
time
Specifies time in seconds. The range is 1 to 3600. The default
value is 60 seconds.
Description
Use this command to change the interval to check the DHCP Snooping
table. The switch checks dynamic entries at the specified intervals and
deletes the dynamic entries that the IP address is expired in.
Confirmation Command
“SHOW DHCPSNOOPING” on page 328
Example
The following command changes the interval to 40 seconds:
Manager > reset dhcpsnooping checkinterval=40
To Next Page
Loading...
