AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 339
SET POE PORT
Syntax
set poe port[=
port_list
|all] [priority=low|high|critical]
[powerlimit=
power_limit
]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
priority
Specifies the power supply priority to the port. The options are low,
high, and critical. The critical is the highest priority. The default
setting is low. When ports have the same priority, the port with the
smaller port number has a higher priority.
power_limit
Specifies the power limit in mili-watts. The default setting is 30000
mili-watts. The switch does not supply power to a PD that
consumes more than the power limit.
Description
Use this command to specify the power supply priority and power limit on
the ports.
The PoE commands are available only for the GS908M V2-4PS
switch.
Here are the guidelines for using the SET POE PORT command:
You can use this command only on PoE ports, port 1 to 4.
When the power management mode is class, the maximum power
supplied to the port is the power level of the PD class if the power
level of the PD is larger than the power limit.
When the power management mode is class, the maximum power
is the power limit specified by this command if the power level of
the PD is smaller than the power limit.
To Next Page
Loading...
Need help?
General
