Chapter 14: Switching Commands
220 Section III: Layer 2 Switching
“DISABLE SWITCH
POWERSAVE” on page 236
Disables the power saving mode on the switch.
“DISABLE SWITCH
STORMDETECTION” on
page 237
Disables detecting the receiving rate.
“ENABLE SWITCH
BPDUFORWARDING” on
page 238
Enables Bridge Protocol Data Unit (BPDU)
protection.
“ENABLE SWITCH
EAPFORWARDING” on page 239
Enables Extensible Authentication Protocol
(EAP) authentication.
“ENABLE SWITCH INFILTERING”
on page 240
Enables the ingress filtering feature.
“ENABLE SWITCH
LOOPDETECTION” on page 241
Enables loop detection.
“ENABLE SWITCH MIRROR” on
page 242
Enables port mirroring.
“ENABLE SWITCH PORT” on
page 243
Enables switch ports.
“ENABLE SWITCH PORT
AUTOMDI” on page 244
Enables ports to automatically detect MDI or
MDI-X.
“ENABLE SWITCH PORT FLOW”
on page 245
Enables Flow Control on ports.
“ENABLE SWITCH
POWERSAVE” on page 246
Enables the power saving mode on the switch.
“ENABLE SWITCH
STORMDETECTION” on
page 247
Enables Storm Detection.
“RESET SWITCH” on page 248 Clears dynamically learned information, timers,
and statistics counters.
“RESET SWITCH
LOOPDETECTION COUNTER”
on page 249
Clears counters for Loop Detection.
“RESET SWITCH PORT” on
page 250
Resets ports by starting Auto-negotiation and
clears statistics counters.
Table 31. Switching Commands (Continued)
Command Description
To Next Page
Loading...
