Chapter 14: Switching Commands
262 Section III: Layer 2 Switching
combo parameter is set to fiber or copper. When the combo
parameter is fiber or copper on a combo port, you can set the
speed to 1000mfull. Otherwise, the speed is always
autonegotiated on combo ports.
When the speed is set to 10mhalf, 10mfull, 100mhalf, or 100mfull,
the polarity cannot be automatically set. When the speed is set to
autonegotiate, 10mhauto, 10mfauto, 100mhauto, 100mfauto, or
100mfull, the polarity is automatically set.
When LDF or receiving rate detection is enabled and the action
parameter is bcdiscard on the port, the bclimit, dlflimit, and mclimit
parameters cannot be set to on.
Multicast MC addresses that is not specified by the ADD SWITH
FILTER command are not protected by storm protection.
The reserved multicast MAC addresses, 01-80-c2-00-00-00 to 02-
80-c2-00-00-2f, are not protected by storm protection.
When the port was disabled by the disable action of the
intrusionaction parameter, the port is still disabled after rebooting if
the configuration is saved before rebooting. To enable the port, run
the enable switch port command.
100M SFP ports cannot be a trunk member.
Confirmation Command
“SHOW SWITCH PORT” on page 272
Example
The following command sets port 1 to 100M speed and half duplex mode:
Manager > set switch port=1 speed=100mhalf
To Next Page
Loading...
