Allied Telesis AT-GS900M Series - Page 392

Chapter 21: Multiple Spanning Tree Protocol (MSTP) Commands
392 Section III: Layer 2 Switching
protocolversion
Specifies the protocol version.
mstp
Specifies MSTP version.
stpcompatible
Specifies MSTP version using STP BPDUs.
Description
Use this command to change the following MSTP parameters of the
switch:
 MST region
 Revision of the MST region
 Maximum hops
 Maximum age time
 Hello time
 Forwarding delay
 Protocol version
Confirmation Command
“SHOW MSTP” on page 399
Examples
The following command changes the revision of the MST region:
set mstp revisionlevel=2