Chapter 22: Access Filter Commands
414 Section IV: Security and Traffic Control
port_list
Specifies a switch port number or list of port numbers. To specify
multiple port numbers, separate port numbers using a comma or
use a hyphen to specify the range of port numbers.
all
Specifies all the switch ports.
Description
Use this command to change the settings of the specified access filter
entry.
Confirmation Command
“SHOW ACCESS FILTER” on page 415
Example
The following command changes the access filter entry 1 of the access
filter group Telnet:
Manager > set access filter=telnet entry=1
ipaddress=192.168.1.2 mask=255.255.255.255 action=pass
port1-7
To Next Page
Loading...
