Chapter 26: Policy-Based QoS Commands
488 Section IV: Security and Traffic Control
burst_size
Specifies the buffer size, or token packet size of the traffic class.
This value is effective when the maximum bandwidth is specified.
The range is 4 to 512 Kbps.
priority
Specifies the priority for the traffic class.
remarkpriority
Specifies yes, no, or none to the state that the switch overwrites
the user priority of a received packet with the priority.
tos_value
Specifies a value for the ToS field of the IP header.
movetostopriority
Specifies yes, no, or none to the state that the ToS value of the IP
header is used to determine the priority.
moveprioritytotos
Specifies yes, no, or none to the state that the priority is used for
the ToS value.
yes, on, true
Yes to the parameter state.
no, off, false
No to the parameter state.
flowgrouplist
Specifies a list of flow groups. To specify multiple flow groups, use
a comma (,) to separate them. To specify a range of flow groups,
use a hyphen (-).
Description
Use this command to change the settings of the traffic class.
Confirmation Command
“SHOW QOS TRAFFICCLASS” on page 496
Example
The following command changes the maxbandwidth of traffic class 1 to
500 Mbps:
Manager > set qos trafficclass=1 maxbandwidth=500
To Next Page
Loading...
Need help?
General
