AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 515
1
Specifies the version 1 of EAPOL, IEEE802.1x-2001 compliant
mode.
2
Specifies the version 2 of EAPOL, IEEE802.1x-2004 compliant
mode.
servertimeout
Specifies the maximum amount of time in seconds that the 802.1x
or Web-based authenticator port waits for a response from a
RADIUS authentication server after sending an Access-request.
The range is 1 to 600 seconds. The default setting is 30 seconds.
quietperiod
Specifies the amount of time in seconds that the 802.1x, MAC
address-based, or Web-based authenticator port discards all
EAPOL packets from supplicants. The range is 0 to 65535
seconds. The default setting is 60 seconds.
txperiod
Specifies the interval in seconds that the 802.1x authenticator port
resends EAPOL packets to supplicants.The range is 1 to 65535
seconds. The default setting is 30 seconds.
reauthperiod
Specifies the interval in seconds that the 802.1x or MAC address-
based authenticator port re-authenticates supplicants. Tthe Web-
based authenticator port does not re-authenticate automatically so
that the link is disconnected when the reauthperiod has passed.
The range is 1 to 86400 seconds. The default setting is 3600
seconds.
supptimeout
Specifies the maximum amount of time in seconds that the 802.1x
authenticator port waits for a response from a supplicant after
sending an EAP-request. The range is 1 to 600 seconds. The
default setting is 30 seconds.
maxreq
Specifies how many times the 802.1x or Web-based authenticator
port resends an EAPOL-request packet to a supplicant.The range
is 1 to 10 seconds. The default setting is 2 times.
reauthenabled
Specifies that the 802.1x, MAC address-based, or Web-based
authenticator port enables or disables re-authentication. When re-
authentication is enabled, Web-based authenticator port is
disconnected after the reauthperiod has passed. By default, re-
authentication is enabled.
To Next Page
Loading...
