Interactive Set-Up
88 AX3000 Models 90 - User's Manual
3.6.2 - Auto-Configuration
The Auto-Configuration function lets a thin client check if new firmware and/or
new configuration files are available.
This function is automatically started when the thin client is powered-on for the
very first time. See Chapter 2.2.
Additionally this function can also be set to run each time the thin client boots:
The 'time-out' parameter is the maximum number of seconds allowed for the
thin client to load a new firmware/configuration. If nothing is received in this time
the thin client boots up using existing current settings.
Two methods are available for the thin client to locate the AxRM server (IP
address and TCP port):
- Static: the IP address (or the name) and the TCP port are entered
- Dynamic (only if DHCP is already used to get the thin client IP address):
the IP address and TCP port are given through the DHCP protocol (see
Chapter 2.2.3 for more information).
For more information about Auto-Configuration stages, refer to Chapter 2.2.
3.6.3 - Factory Settings
This allows, after confirmation, thin client factory settings to be reloaded. The
current configuration is lost. See Appendix A.7.1.
To Next Page
Loading...
Need help?
General
