Initial Power-On
AX3000 Models 90 - User's Manual 25
The [Advanced Setup] button enters the interactive setup where further
configuring is possible. For example adding different session types.
2.2 - AUTO-CONFIGURATION
The Auto-Configuration feature allows a brand new ‘out of the box’ thin client to
be sent a specific firmware and/or configuration file without any human
intervention. There are also options to specify various thin client specific
parameters, for example an IP address and thin client name etc.
For more information on AxRM’s activity in the auto-configuration process, see
the manual "Axel Remote Management", available from www.axel.com.
The auto-configuration process:
- Is automatically initiated when power is applied to a brand new thin client
or if the thin client is reset to factory defaults - see A.10.1 appendix.
- may be started at each boot time. For more information see Chapter
3.6.2.
The stages are:
- Checking the network (link),
- DHCP request sent to obtain an IP address and other parameters
(optional),
- Thin client contacts the AxRM server,
- Firmware file sent (if required), followed by a reboot,
- Configuration file sent, followed by a reboot.
Total process takes less than two minutes
2.2.1 - Stage 1: Checking the Network
When the thin client is powered up the network connection is tested. The thin
client displays ‘Checking Network Link’. If a network connection is detected, a
message ' Auto-Conf' is shown. The thin client passes to stage 2.
Auto-conf.
To Next Page
Loading...
Need help?
General
