Installing under OS/400
AX3000 Models 90 - User's Manual 175
Example 1: Screen session, character mode
When this EBCDIC data is received:
@%@1/1Bat/2F@%@ (44 6C 44 F1 61 F1 C2 81 A3 61 F2 C6 44 6C 44)
This ASCII data is sent to the AUX1 port:
<ESC>at/ (1B 61 74 2F)
Example 2: Printer Session, character mode
When this EBCDIC data is received:
@%@/1Bat/2F@%@ (44 6C 44 F1 61 F1 C2 81 A3 61 F2 C6 44 6C 44)
This ASCII data is sent to the auxiliary port of this printer session:
<ESC>at/ (1B 61 74 2F)
e) Handling DTR and RTS Signals
The transparent mode can also be used to control, from a screen session, DTR
and RTS output signals.
The command syntax is the following:
@DTR Port Action
@RTS Port Action
Where:
Port: port numbers are listed in sub-section b
Action: signal is low if this value is 0. Else signal is high.
6.3 - 5250 PRINTER
Auxiliary ports, USB logical ports and network printer ports are provided by the
AX3000. These ports are independently controlled so multiple printers can be
attached to the AX3000.
To Next Page
Loading...
Need help?
General
