Installing under Windows
AX3000 Models 90 - User's Manual 119
Set the 'Active' parameter to 'As Printer' or 'As Printer and COM'. Then select
'Printer Parameters'. The following box is displayed:
These parameters are:
- Printer Name: name of the Windows printer
- Windows Native Driver: printer driver name. It is ESSENTIAL that the
value entered here matches the printer driver name exactly as installed
on the server. If the match is not exact Windows will not be able to
connect the printer to the driver and the printer will not be added to the
Windows spooler.
- Time-out (sec): in event of a printer error (no paper, off-line, etc.), this is
the delay before the thin client reports the error to Windows.
- Save Printing Option: when the default printer configuration is modified
(on the server side), this option allows the thin client to store this
configuration (in the AX3000 Local Store). See Chapter 3.6.4.
The printer declaration is completed. For the redirection procedure, consult the
sub-section c).
b) Declaring a Redirected COM/LPT Port
On an RDP/ICA connection a redirected COM/LPT port will be automatically
added to the Windows server resources. It will be removed on disconnection.
Maximum two ports can be redirected.
Before being redirected an RDP/ICA COM Port must be declared at the
'physical port' level. The available ports are USB logical ports.
To Next Page
Loading...
Need help?
General
