Installing under OS/400
168 AX3000 Models 90 - User's Manual
Important: the auto-signon function must be allowed at the OS/400 level. To
enable it set the QRMTSIGN variable to *VERIFY (command CFGTCP).
6.1.6 - Connection Properties
The following box is displayed:
These parameters are:
- TERM Value: terminal capabilities. Default value is IBM-3477-FC.
- Auto-Connection: if this parameter is set to 'yes', the connection will be
automatically established when the AX3000 is powered. Otherwise, the
user can press <Alt><Fx> to establish the connection.
- Auto-Reconnection: if this parameter is set to 'yes', a new connection is
automatically established after a disconnection. Otherwise, the user can
press <Alt><Fx> to establish a new connection.
- Session Label: this character string (11 characters max.) is used to
identify the session within the local desktop or in the taskbar.
- Enhanced Parameters: see Appendix A.7.3.
6.2 - USING THE AX3000
6.2.1 - The 5250 Status Line
Note: the 5250 status line is different than the AX3000 TCP/IP status line. (The
AX3000 TCP/IP status line displays information about current connected
sessions. This line can be enabled/disabled through the AX3000 Set-Up).
The 5250 status line is displayed at the bottom of the screen and gives the
To Next Page
Loading...
Need help?
General
