Initial Power-On
12 AX3000 Models 90 - User's Manual
This chapter describes the 'Quick Set-Up' feature and the 'Auto-Configuration'
service.
When the thin client is switched on up for the very first time two configuration
methods are available:
- Quick Set-Up: a wizard allows the thin client to be set-up in few seconds
for typical use.
- Auto-Configuration: used in conjunction with AxRM, this function allows
the thin client to receive new firmware and/or a configuration.
IMPORTANT: the auto-configuration must use the Ethernet interface,
i.e. not applicable through Wireless interface.
2.1 - QUICK SET-UP
This feature is automatically run when the thin client is powered up for the first
time or can be accessed at any time from the interactive set-up, by pressing
Ctrl-Alt-Esc ([Configuration]-[Quick set-up]).
The quick set-up is designed for a typical simple environment of:
- One server
- An optional router
- All sessions set identically
- Remote Control
- Optional printer and memory stick
Note: After the ’Quick set-up’ is run all other parameters within the thin client
are reset to their factory default values.
The ‘quick set-up’ guides the user through a setup menus in an intuitive
manner.
To Next Page
Loading...
Need help?
General
