Appendix
AX3000 Models 90 - User's Manual 273
All these general parameters are located in sub-menus from [Configuration]-
[Advanced]-[Tuning]:
a) Network Menu
IP Addr. Set by Ping: this parameter allows or disables the AX3000 IP Address
to be set by a ping command. (See Appendix A.7.6.)
Allow Network Discover: by default, SNMP requests are supported by Axel
thin clients. This allows thin clients to be discovered by AxRM (the Axel
administration software). This parameter can be used to disabled the SNMP
support.
DNS Trace Mode: turn on/off DNS trace messages.
MTU: set the Maximum Transfer Unit value (Ethernet layer).
To Next Page
Loading...
Need help?
General
