©2020 Baxter International Inc. 5- 57
Performing a Dynamic Assessment Test
2. Observe the displayed Test Results. If more than one Test performed, swipe the
display
left
or
right
to move through the Results, as required.
Note
By default, in the SVI Trend area (labeled [
1
] in Figure 5-52) the focus is shown on the Last Test
performed.
3. If necessary, use the Display Control Knob to move the focus from one column to
another. Turn the knob
left
or
right
, as required. See Note below.
The screen refreshes, displaying the continuous results of the SVI during the selected
Test in the corresponding area (labeled [
2
] in Figure 5-52).
Note
In the event that there are more than four Dynamic Assessment Tests in the Session, use of the
Display Control Knob will be necessary to access those not currently visible.
By default, the column positioned on the most-right is that of the last Test performed in the
Session.
To Next Page
Loading...
