CAPINTEC, INC. CAPTUS
®
3000
INSTALLATION
Your system has been shipped from the factory pre-configured and fully tested. Installation
consists of placing the components and securing them in place. Detailed installation and
assembly instructions are provided in the included Unpacking and Assembly Instructions
for your system.
IMPORTANT SAFETY INFORMATION
The CAPTUS
®
3000 measurement system has been carefully designed to give you years of
safe and reliable performance. As with all electrical equipment, however, there are basic
precautions you must observe to avoid injuring yourself, the patient or damaging the
equipment.
• Follow the unpacking and assembly instructions document, and read this manual
carefully before using this equipment. Be sure to save all provided documents for
future reference.
• Understand all warning and caution labels as explained in the CHAPTER 1:
SAFETY before operating this equipment.
TRADEMARKS
CAPTUS
®
3000
and CII are registered trademarks of Capintec, Inc.
Microsoft
®
and MS Windows
®
are U.S. registered trademarks of the Microsoft Corporation.
Hewlett Packard
®
DeskJet is a registered trademark of the Hewlett Packard Company.
November 13 PREFACE P-3
To Next Page
Loading...
Need help?
General
