CAPINTEC, INC. CAPTUS
®
3000
CHAPTER 6
ISOTOPES
INTRODUCTION ............................................................................................. 6-1
VIEWING AND PRINTING ISOTOPE LIBRARY ............................................. 6-2
ADDING A NEW ISOTOPE TO THE LIBRARY .............................................. 6-3
EDITING ISOTOPE INFORMATION ............................................................... 6-4
DELETING AN ISOTOPE ................................................................................ 6-5
MEASURING EFFICIENCY ............................................................................. 6-5
ENTERING EFFICIENCY ................................................................................ 6-9
CAUTION: To ensure optimum performance of CAPTUS
®
3000, before using
the Isotopes module, perform the System Setup Procedures as
outlined in CHAPTER 4: GENERAL SETUP.
INTRODUCTION
The CAPTUS
®
3000 has an extensive reference library of at least 76 isotopes that contains
information on their half-lives, major energy peaks, and known efficiencies. This information
is used in the identification of isotope peaks in MCA, Wipe Test module, radioactive decay
corrections and measurement of efficiencies. The user may add new isotopes to this list if
required.
To access the Isotopes module, click the
button or press Alt+I on the CAPTUS
®
3000 Main screen. Figure 6-1 Isotopes Main Screen will appear.
November 13 ISOTOPES 6-1
To Next Page
Loading...
Need help?
General
