CAPINTEC, INC. CAPTUS
®
3000
Making Measurements
CAUTION: Calibration is recommended before making any measurements. Refer to
CHAPTER 5: QUALITY ASSURANCE TESTS; SECTION: AUTO
• Before making any measurements on a patient, verify that all required patient information
has been entered.
• Make sure the default settings on Edit Patient screen and the Setup screen are
appropriate. The values on Edit Patient screen override those on the Setup screen.
1. To select a patient for the test, click on that record in the Patient Directory box on Figure
10-45 Cr51 Blood Volume Test Main Screen. The Patient Status box will show the
current status of the patient. If this box reads, “All Data has been entered”, the
button at the bottom of the screen is accessible and the test can
be started. If data is partially entered, the
button is inaccessible.
Note: If the Patient Status box shows “Data Partially Entered”, no measurements can
be made until all the required information is entered. Refer to Editing Patient
Information on page 10-35.
2. To begin the measurements, click the
button or press Alt+C. The
screen appears as shown in Figure 10-54.
Note: If calibration has not been performed, you will be prompted with the screen as
shown in Figure 10-54. After the calibration is complete, the program will return to
the Schilling Test measurement screen shown in Figure 10-55.
Figure 10-54
10-38 LAB TESTS November 13
To Next Page
Loading...
Need help?
General
