CAPINTEC, INC. CAPTUS
®
3000
CHAPTER 15
CLEANING AND MAINTENANCE
INTRODUCTION ..............................................................................................15-1
CLEANING and DISINFECTING .....................................................................15-2
Cleaning Instructions .................................................................................15-2
Disinfecting Instructions............................................................................15-3
PREVENTIVE MAINTENANCE .......................................................................15-4
DISPOSAL .......................................................................................................15-4
Floor Stand..................................................................................................15-5
Table Top Stand..........................................................................................15-6
SERVICING......................................................................................................15-7
Collimator Block Inspection.......................................................................15-7
Spring-Arm Inspection ...............................................................................15-8
Computer Battery Replacement ................................................................15-9
FUSE SERVICING ...........................................................................................15-9
Power Line Fuses........................................................................................15-9
Computer, Monitor and Printer Fuses......................................................15-10
ACCESSORIES AND REPLACEMENT PARTS ............................................15-10
SHIPPING........................................................................................................15-11
INTRODUCTION
This chapter provides the information necessary for the user to perform the basic
maintenance of instrument cleaning, fuse replacement and general preventative
maintenance. There are no internal adjustments or calibration settings that may be done by
the user within the conditions of the warranty.
CAUTION: REFER ALL SERVICING TO A QUALIFIED SERVICE
REPRESENTATIVE!
It is recommended that periodic (every three to five years) re-calibration of the CAPTUS
®
3000 be performed only by Capintec’s Authorized Service Center to guarantee the
instrument’s high reliability is maintained. Contact Capintec’s only
Authorized Service Center
in Pittsburgh for servicing or re-calibration at 1-800-227-6832.
January 13 CLEANING AND MAINTENANCE 15-1
To Next Page
Loading...
Need help?
General
