InteliDrive DCU Marine - 3.0.0 Global Guide
11
7 Memo1 Each time rising edge is detected with LBI: Memo1 Trigger
8 Memo2 Each time rising edge is detected with LBI: Memo2 Trigger
9 MomAvgFlCon L
Momentary average fuel consumption per nautical mile. Calculated from fuel
consumption and boat speed.
Result is not rounded, e.g. 9/100 is displayed as 0,0
If FuelConsumpt is 0 then MomAvgFlCon L is displayed as invalid value #####.
Note: Statistic values can be adjusted from InteliMonitor, password 3 level protected by default.
Note: Internal display does not support Unsigned Long values so it does not display correctly values higher
than 2,147,483,647. Could be roughly says that issue is connected with values having 10 digits and more.If
there is higher value, it treats it as Signed long and show it as negative with "-" (minus sign).Workaround: If
numbers with 10 digits has unlogically minus mark number should be recalculated.
History records
Following table does not contain Wrn, Sd and Fls messages from external units.
Events specification Protection type Information available on binary output
Alarms
Wrn Analog input 1 to 8 WRN YES
Sd Analog input 1 to 8 SD YES
ID-DCU MARINE Binary input 1 to 14 Configurable YES
ID-DCU MARINE Battery voltage <, > WRN YES
Wrn SHBIN 1 to 6 WRN
Sd SHBIN1 to 6 SD
Wrn DISTBIN 1 to 32 WRN
Sd DISTBIN1 to 32 SD
Wrn SHAIN 1 to 4 WRN
Sd SHAIN1 to 4 SD
Wrn CommError(1) to (10) WRN
Sd CommError(1) to (10) SD
Wrn RPU Fail WRN
Sd RPU Fail SD
Bw RPU FuelSol BW
Bw RPU StopSol BW
Wrn RPU Fail WRN
Sd RPU Fail SD
ID-RPU A Battery voltage <, > WRN
ID-RPU B Battery voltage <, > WRN
Wrn DETCON WRN
Sd DETCON SD
To Next Page
Loading...
Need help?
General
