EasyManuals Logo

ComAp InteliDrive DCU Marine User Manual

ComAp InteliDrive DCU Marine
285 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #118 background imageLoading...
Page #118 background image
InteliDrive DCU Marine - 3.0.0 Global Guide
118
Setpoint group Comms Settings Related FW 3.0.0
Range [units] 1 .. 32 [-]
Default value 1
Step 1
Comm object 24537 Related applications All
Config level Standard
Setpoint visibility Always
Description
Controller identification number. Each controller in the group has to have its own unique number. Default
value is 1.
Note: The InteliDrive ControllerAddr must correspond to InteliMonitor or DriveConfig communication
setup setting when opening Direct or Modem connection.
ControllerAddr
6 back to List of setpoints
Setpoint group Comms Settings Related FW 3.0.0
Range [units] [ENABLED, DISABLED, EXTERNAL]
Default value ENABLED
Step [-]
Comm object 10353 Related applications All
Config level Standard
Setpoint visibility Always
Description
This setpoint is used to disable reading of diagnostic codes from ECU if an external diagnostic tool is
connected to engine.
Message ECU Diag disabled is displayed in the alarm list while ECU diagnostics is disabled.
The ECU Diagnostic is disabled/enabled using LBI:ECU DiagBlck binary input in case of setting to
EXTERNAL.
ECU Diag
6 back to List of setpoints

Table of Contents

Other manuals for ComAp InteliDrive DCU Marine

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ComAp InteliDrive DCU Marine and is the answer not in the manual?

ComAp InteliDrive DCU Marine Specifications

General IconGeneral
BrandComAp
ModelInteliDrive DCU Marine
CategoryController
LanguageEnglish

Related product manuals