ComAp InteliDrive DCU Marine - Timer off; Timer Repeat

InteliDrive DCU Marine - 3.0.0 Global Guide
116
Setpoint group Basic settings Related FW 3.0.0
Range [units] [hh:mm:ss]
Default value 0:00:00
Step [-]
Comm object 10199 Related applications All
Config level Standard
Setpoint visibility Always
Description
See Timer Repeat (page 116) description.
Timer OFF
6 back to List of setpoints
Setpoint group Basic settings Related FW 3.0.0
Range [units] [Never, Mon-Fri, Mon-Sat, Mon-Sun, Sat-Sun ]
Default value NEVER
Step [-]
Comm object 10045 Related applications All
Config level Standard
Setpoint visibility Always
Description
Logical binary output Timer Active is closed when actual time is over the Timer ON and opened when actual
time is over Timer OFF. The function depends on Timer Repeat settings. The output is closed when
controller is switched On and Timer settings corresponds to closed state.
Timer Repeat
6 back to List of setpoints