ComAp InteliDrive DCU Marine - Clutchbttoggle; HEST Lamp; Starter; Stop Solenoid

InteliDrive DCU Marine - 3.0.0 Global Guide
203
Related FW 3.0.0 Related applications All
Comm object 1461
Description
The first press of 0/1- panel Close Load button activates the new LBO ClutchBtToggle, the second press
deactivates it, The function operates in all engine modes and states and can be used for some independent
PLC function when standard Clutch function is not used.
Existing function of pnael Close load button 0/1(LBO Close Load) is without change.
Close Load function works for remote access from DriveMonitor, Modbus, Modem, ... as well.
ClutchBtToggle
6 back to List of LBO
Related FW 3.0.0 Related applications All
Comm object 39
Description
The output closes during engine start, after Idle time setpoint elapses. The output opens again after Cooling
time is finished. The opposite logic output Nominal/Idle is available as well.
Note: Connect Binary output Idle/Nominal to electronic speed governor to switch the speed: opened =
IDLE, closed=RATED.
Idle/Nominal
6 back to List of LBO
Related FW 3.0.0 Related applications All
Comm object 1373
Description
Indicates High Exhaust System Temperature (HEST). It may be active during DPF regeneration to indicate
higher than normal exhaust temperatures.
HESTLamp
6 back to List of LBO
Related FW 3.0.0 Related applications All
Comm object 24
Description
Closed output energizes the engine starter.
Starter
6 back to List of LBO
Related FW 3.0.0 Related applications All
Comm object 23
Description
Output is closed during engine stopping procedure.
Stop Solenoid
6 back to List of LBO