ComAp InteliDrive DCU Marine - Requested RPM; Engine Torque (PRP Only); Fuel Consact

InteliDrive DCU Marine - 3.0.0 Global Guide
245
Related FW 3.0.0 Related applications All
Comm object 68
Description
AI influences directly Engine Values: Speed Request register when configured without ramp. In the case of
sensor fail (out of range) is Speed request = 0,0% for PRP and 50,0% (=Nominal RPM) for AUX. There is
expected range of values 0,0 … 100,0% for this Logical Analog input.
See Engine Values: Speed Request charts for (page 267) and (page 267) modes.
Requested RPM
6 back to List of LAI
Related FW 3.0.0 Related applications PRP
Comm object 69
Description
Actual engine torque in %, received from J1939.
Engine Torque (PRP only)
6 back to List of LAI
Related FW 3.0.0 Related applications All
Comm object 82
Description
There are two cumulative Statistics registers - values TripCons and DayCons. Those statistic values
increment value based on sampling of Logical Analog Input Fuel ConsAct. LAI can be sourced from ECU
Fuel Rate [l/h ] or separate Actual Fuel consumption sensor connected to physical Analog input.
Both statistics values is possible to modify in InteliMonitor – Set Statistics command or clear by Logical
Binary Inputs ClearDayCons or ClearTripCons.
Fuel ConsAct
6 back to List of LAI