ComAp InteliDrive DCU Marine - Source: RPU Unit; FS-Status; FS-Load; SS-Status

InteliDrive DCU Marine - 3.0.0 Global Guide
220
Source: RPU unit
Values of ID-RPU unit are available (visible) only when ID-RPU module is selected. States does not activate
Alarms.
Following list contains ID-RPU Shut down inputs state that can be configured to Binary outputs.
RPU-SD 1 Indication of ID-RPU Shut down 1 input state.
RPU-SD 2 Indication of ID-RPU Shut down 2 input state.
RPU-SD 3 Indication of ID-RPU Shut down 3 input state.
RPU-SD 4 Indication of ID-RPU Shut down 4 input state.
RPU-SD 5 Indication of ID-RPU Shut down 5 input state.
EmStop RPU Indication of ID-RPU Emergency stop input state.
Related FW 3.0.0 Related applications RPU
Comm object 10213
Description
Binary output Fuel solenoid (FS) status when output is opened:
0 OK
1 Fail: Broken wire(BW)
Table 8.1 FS-Status
Note: The High Current is indicated if output current is over 1A approx.
FS-Status
6 back to List of LBO
Related FW 3.0.0 Related applications RPU
Comm object 10213
Description
Binary output Fuel solenoid (FS) status when output is opened:
0 OK
1 Fail: Broken wire(BW)
Table 8.2 FS-Load
FS-Load
6 back to List of LBO
Related FW 3.0.0 Related applications RPU
Comm object 10213
Description
Binary output Stop solenoid (SS) status when output is closed – see FS-Status (page 220)
SS-Status
6 back to List of LBO