ComAp InteliDrive DCU Marine - ID-RPU Wiring; Recommended Wiring Acording to DNV Rules

InteliDrive DCU Marine - 3.0.0 Global Guide
53
4.2.5 ID-RPU wiring
Note:
BW protection of the ID-RPU outputs Fuel solenoid and Stop solenoid is active in open state only.
To avoid BW detection configure not wired inputs or outputs of ID-RPU as Not used by DriveConfig sw.
Battery minus terminals are separated.
See also Recommended wiring acording to DNV rules (page 53).
4.2.6 Recommended wiring acording to DNV rules
There is recommended wiring diagram of InteliDrive DCU Marine controller + ID-RPU module following latest
DNV requirements for mutual independency of control, alarm and safety systems. InteliDrive DCU Marine
provides features of control and alarm system, ID-RPU provides features of safety system.