ComAp InteliDrive DCU Marine User Manual

InteliDrive DCU Marine - 3.0.0 Global Guide
199
Source: Log Bout
Related FW 3.0.0 Related applications All
Comm object 1828
Description
Indicates that engine issued a warning.
AmberLamp
6 back to List of LBO
Related FW 3.0.0 Related applications All
Comm object 1842
Description
Indicates that Aftertreatment control is available with configured engine support.
Aftertreatment
6 back to List of LBO
Related FW 3.0.0 Related applications All
Comm object 1831
Description
Active signal indicates that DPF (Diesel Particulate Filter) is starting to overfill with soot because the
system is unable to undertake an automatic active regeneration. It starts flashing when the DPF is nearly
full, engine power may be reduced.
DPF Lamp
6 back to List of LBO
Related FW 3.0.0 Related applications All
Comm object 1373
Description
Indicates High Exhaust System Temperature (HEST). It may be active during DPF regeneration to indicate
higher than normal exhaust temperatures.
HESTLamp
6 back to List of LBO
Related FW 3.0.0 Related applications All
Comm object 1
Description
Binary output for Horn, Buzzer alarm acoustic indication. Output is automatically switched off after Engine
protection: Horn timeout. Horn is active unlimited time (until Fault reset) when Horn timeout = 0.
Horn
6 back to List of LBO

ComAp InteliDrive DCU Marine Specifications

General

Brand	ComAp
Model	InteliDrive DCU Marine
Category	Controller
Language	English