© 06/2006 8167-001
1/10
TCD 2015
Drive system
W 02-03-01
6
Checking the con rod
Commercial available tools:
– Micrometer gauge
– Internal measuring device
– Con rod test device
Special tools:
– Dial gauge. . . . . . . . . . . . . . . . . . 100400
– W 02-09-03
z Remove piston and connecting rod.
W 02-09-03
© 40592-0
Checking small end bush
z Prepare internal measuring device:
– Mount probe bolt for the appropriate measuring
range in the internal measuring device.
– Mount dial gauge with approx. 1 mm pre-tension in
the internal measuring device.
– Set micrometer gauge to 52 mm.
– Balance the internal measuring device between
the test surfaces of the micrometer gauge and set
the meter at the reversal point of the pointer to "0".
© 34768-2
To Next Page
Loading...
