TCD 2015
Other components
W 12-06-03
© 06/2006 8242-001
2/4
6
z Visually inspect joint (arrow) and contact surface.
z Clean flywheel.
The joint and contact surface must be free
from grease and dirt.
© 34765-2
Install toothed starter ring
z Check marking of new toothed starter ring.
The marking (arrow) is on the flywheel and
exactly in the middle of the tooth notch of
the toothed starter ring.
© 40905-0
z Heat up toothed starter ring to 220 °C.
z Place toothed starter ring on flywheel.
The markings on the flywheel and toothed
starter ring must match.
The toothed starter ring must lie evenly on
the joint of the flywheel.
© 40906-0
To Next Page
Loading...
