© 06/2006 8177-001
1/2
TCD 2015
Crankcase
W 03-03-08
6
Checking the overhang of the cylinder liner
Commercial available tools:
– Magnetic measuring stand
Special tools:
– Dial gauge. . . . . . . . . . . . . . . . . . 100400
– W 01-04-04
Checking the overhang of the cylinder lin-
er
z Remove cylinder head.
W 01-04-04
z Insert screws and washers (1) diagonally opposed.
z Tighten screws until they touch the cylinder liner.
Washers:
Maximum thickness 4 mm
Screw length:
M16 x 90
1
© 45424-0
z Mount magnetic measuring stand.
z Insert dial gauge.
z Apply stylus of the dial gauge to the crankcase seal-
ing surface with pre-tension (arrow).
z Turn the dial until the pointer points to "0".
© 45762-0
To Next Page
Loading...
