© 06/2006 8223-001
1/14
TCD 2015
Fuel system
W 07-10-06
6
Removing and installing fuel pipes
Commercial available tools:
– Open wrench size SW 22
Special tools:
– Plugs/caps . . . . . . . . . . . . . . . . . 170160
– W 06-07-03 . . . . . . . . . . . . (A-bank)
– W 06-07-03 . . . . . . . . . . . . (B-bank)
Attention!
Pay attention to utmost cleanliness when
working on the fuel system.
Remove residue paint and particles of dirt
before removing.
Clean the respective affected parts care-
fully. Blow damp areas dry with compres-
sed air.
Observe the safety regulations and natio-
nal specifications for handling fuels.
Close all connections immediately after
opening with new, clean plugs/caps.
Do not remove plugs/caps until immedia-
tely before assembling.
Collect leaking operating substances in
suitable vessels and dispose of according
to regulations.
Ensure that the cables are connected pro-
perly.
Removing fuel pipes
z Remove charge air pipe (A-bank).
W 06-07-03
z Remove charge air pipe (B-bank).
W 06-07-03
© 40606-0
To Next Page
Loading...
