© 06/2006 8217-001
1/8
TCD 2015
Fuel system
W 07-04-01
6
Removing and installing injection pumps
(Cylinder A2-B3)
Commercial available tools
Special tools:
– Plugs/caps . . . . . . . . . . . . . . . . . 170160
– Locking agent
DEUTZ DW 59
– W 03-01-11
– W 04-06-03
– W 07-03-01 . . . . . . . . . . . . (A-bank)
– W 07-03-01 . . . . . . . . . . . . (B-bank)
– W 07-10-06
– W 07-10-06 . . . . . . . . . . . . (Railway)
Attention!
Pay attention to utmost cleanliness when
working on the fuel system.
Remove residue paint and particles of dirt
before removing.
Clean the respective affected parts care-
fully. Blow damp areas dry with compres-
sed air.
Observe the safety regulations and natio-
nal specifications for handling fuels.
Close all connections immediately after
opening with new, clean plugs/caps.
Do not remove plugs/caps until immedia-
tely before assembling.
Collect leaking operating substances in
suitable vessels and dispose of according
to regulations.
Read out error memory of the motor con-
trol timer with SERDIA.
Removing injection pumps
z Removing the crankcase breather.
W 03-01-11
z Removing high pressure pipes (A-bank).
W 07-03-01
z Removing high pressure pipes (B-bank).
W 07-03-01
z Unscrew screws (1).
z Place fuel hose (2) to one side.
1
2
© 40554-0
To Next Page
