7.2.7.3 Installing the new 2.5-inch HDD/SSD module
Ê Install the HDD/SSD module as described in section "Installing 2.5-inch
HDD/SSD modules" on page 123.
7.2.7.4 Concluding steps
Ê "Performing a RAID array rebuild" on page 96
7.2.8 Replacing the 4 x 2.5-inch HDD backplane
7.2.8.1 Preliminary steps
Ê "Locating the defective server" on page 45
Ê "Shutting down the server" on page 48
Ê "Disconnecting the server from the mains" on page 49
Ê "Getting access to the component" on page 49
Ê Release all HDD/SSD modules and pull them out a few centimeters, see
section "Removing 2.5-inch HDD/SSD modules" on page 126
I The HDD/SSD modules need not to be removed completely. But if
you want to remove them nevertheless, check if all HDD/SSD
modules are uniquely identified so that you can reinsert them into
their original bays.
Field Replaceable Unit
(FRU)
Hardware: 10 minutes
Tools: tool-less
To Next Page
Loading...
Need help?
General