Figure 81: Connecting the cables to the 3.5-inch HDD backplane
Ê Connect the following cables to the HDD backplane:
– SAS/SATA data cable:
(1), (2), (4), (5) to connectors "P1", "P2", "P3", "P4" according to the
length
(6) plug P6 to connector "SGPIO"
– (3) power cable to connector "PWR"
I If applicable, connect the OOB cable to connector "SMBus" on the
HDD backplane (see figure 78).
For the cable plan see section "Cabling" on page 339.
7.3.5.4 Concluding steps
Ê Insert all HDD modules, see section "Installing a 3.5-inch HDD module" on
page 147.
I Make sure that you reinstall the HDD module in the bay it was located
before the HDD backplane replacement.
Ê "Reassembling" on page 54
Ê "Connecting the server to the mains" on page 60
Ê "Switching on the server" on page 61
To Next Page
Loading...
