Ê "Disconnecting the server from the mains" on page 49
Ê "Getting access to the component" on page 49
Ê "Locating the defective component" on page 47
Ê Remove the corresponding riser module as described in section "Handling
riser modules" on page 62.
9.5.3.2 Removing the defective expansion card
Ê Remove the expansion card as described in section "Removing the
expansion card" on page 194.
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card as described in section "Removing a slot bracket"
on page 172.
9.5.3.3 Installing the new expansion card
Ê If applicable, install the slot bracket as described in section "Installing a slot
bracket" on page 170.
Ê Install the expansion card as described in section "Installing the expansion
card" on page 191.
9.5.3.4 Concluding steps
Ê Install the corresponding riser module as described in section "Handling
riser modules" on page 62.
Ê "Reassembling" on page 54
Ê "Connecting the server to the mains" on page 60
Ê "Enabling replaced components in the system BIOS" on page 90
Ê "Updating RAID controller firmware" on page 82
Ê "Enabling SVOM boot watchdog functionality" on page 89
Ê "Switching on the server" on page 61
Ê "Resuming BitLocker functionality" on page 95
Ê After replacing a network controller in a server running Linux OS, "Updating
the NIC configuration file in a Linux environment" on page 93.
To Next Page
Loading...
