9.5.2.4 Concluding steps
Ê Install the corresponding riser module as described in section "Installing a
riser module" on page 63.
Ê "Reassembling" on page 54
Ê "Connecting the server to the mains" on page 60
Ê "Switching on the server" on page 61
Ê "Resuming BitLocker functionality" on page 95
9.5.3 Replacing an expansion card
Note on network settings recovery
I When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.5.3.1 Preliminary steps
Ê "Locating the defective server" on page 45
Ê If applicable, ensure to note down your current network settings in the
operating system.
Ê "Disabling SVOM boot watchdog functionality" on page 72
Ê "Suspending BitLocker functionality" on page 71
Ê "Shutting down the server" on page 48
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Software: 5 minutes
Tools: slot 1: Phillips PH2 / (+) No. 2 screw driver
slot 2, slot 3, slot 4: tool-less
To Next Page
Loading...
Need help?
General